If your TECNO KE5 is completely dead, not detected in flashing tools, or stuck on the boot logo, this Dead Boot Repair Dump File can bring it back to life. This file is specially prepared and tested on a working TECNO KE5 (QX63AB) model to help you restore your phone’s eMMC and boot partitions using tools like UFI Box, EasyJTAG Plus, or Flash64.
This file includes essential dump partitions such as BOOT1, BOOT2, EXT_CSD, and USERDATA, allowing you to recover dead or bricked devices quickly and safely.
What Is a Dump File?
A dump file is a complete backup of the eMMC (memory chip) taken from a fully working device. It’s used by professional technicians to repair dead boot problems or restore corrupted firmware when normal flashing doesn’t work.
For TECNO KE5 users, this dump helps to:
Fix dead boot or no power issues.
Recover devices not detected in flashing mode.
Repair firmware corruption or boot loop errors.
Restore the original eMMC structure after damage.
Supported Tools & Compatibility
You can use any of the following tools to write this dump:
✅ UFI Box (recommended for automatic partition mapping)
✅ EasyJTAG Plus (manual partition restore supported)
✅ Flash64 Programmer (for chip-level flashing and repair)
Make sure your device’s eMMC chip is readable in ISP or Direct mode before flashing. Always back up your old data if possible.
How To Use This Dump File
Extract the ZIP file: TECNO KE5 Dump eMMC QX63AB.zip
Open your tool (UFI/EasyJTAG/Flash64).
Select eMMC and load dump partitions.
Write BOOT1, BOOT2, EXT_CSD, and USERDATA one by one.
Verify data and reassemble the phone.
Power on – your TECNO KE5 should boot normally again.
This tested TECNO KE5 dump file is perfect for technicians and repair labs looking for a reliable dead boot fix solution for this model.